Continuous Contact Scanning - Form?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Continuous Contact Scanning - Form?

    I'm using the scanning function with my Tesastar M on an ID. Max Increment set to 0.5 mm. Two questions:

    1. How to I change the calculation to 'Max Inscribed', or can I?
    2. How can I report the form (circularity, roundness) of the circle? When I select "Form" in the dialog it still doesn't show up in the measurement. When I go in the measurement and type "RN", it comes up, but always reports 0.0000, perfect form.
    sigpic
    Global Advantage 12-22-10
    TESASTAR M SP25 4.3mr2

  • #2
    Well I guess you all figured that I'd figure this out on my own. I did. I had to use the scan to construct a circle. Duh!
    sigpic
    Global Advantage 12-22-10
    TESASTAR M SP25 4.3mr2

    Comment


    • #3
      You are welcome!
      sigpic"Hated by Many, Loved by Few" _ A.B. - Stone brewery

      Comment

      Related Topics

      Collapse

      Working...
      X