calibrating very small tips

[kyle lattenhauer]

Is there a way to adjust the force during calibration when scanning? I am using a 1mm tip and it seems to "skip" over the top of the qual. tool.
thanks in advance
kyle

ver 3.7 mr2
ph10mq scanning head

[BSchwark]

the ph10mq is the probe head. what kind of probe are you using? a SP600M probe? if it is hit "F10" and look under probe options.

BS

[kyle lattenhauer]

the probe is an sp-25-m

when using f10 these parameters are set on a program by program basis (they will not follow the probe) am i correct?