-
Yes, Adjust your prehit, retract, and manual retract. Usually .5mm or 1mm work good and go from there. BE SURE to increase them though when you go to something else -
scanning question
I have need to do an edge thickness analysis on a couple of parts which will entail doing a scan around the outside edge of the part at a particular depth, then doing another scan around the inside edge to find places where the material gets too thin. When running the scan, I chose to use a line scan, and convert to individual points. When the CMM is taking the hits though, the probe takes a hit, retracts straight out, moves over then takes another hit. Is there a way to "round off" the corners of these movements so the scan takes less time?
Running a mistral 07/07/05 with PC-DMIS 3.7MR3Last edited by d.evans; 07-05-2006, 01:00 PM.
-
For those of you who have more in-depth scanning experience than I:
Any tips or tricks to improve scanning of sharp edges with a touch...01-04-2010, 02:36 PM -
I think I am looking for something like a perimeter scan or a liniar open type scan that takes a sample hit for every point. It would be like a scan...06-10-2006, 09:52 AM
-
I am trying to perform an edge scan, but the machine keeps crashing when I do so. I believe the main reason is my inexperience with a CMM, so I hope...03-22-2006, 11:30 AM
-
I'm digitizing the die steel in the picture below. I'm running version 3.5 and attempting to do an edge scan. My current scan settings are 1 initial and...08-06-2009, 08:12 AM
-
...Code:
SCN9 =FEAT/SCAN,FREEFORM,SHOWHITS=NO,SHOWALLPARAMS=YES EXEC MODE=DEFINED, NOMS MODE=FIND NOMS,CLEARPLANE=NO,SINGLE POINT=NO,THICKNESS=004-24-2007, 10:42 AM
Leave a comment: