Comments in Program

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Comments in Program

    I would like to put in a comment at the very begining of the program that state where to put the risers and clamps for the part that is being run. IE: riser in space 1,3,6 and clamp in space 5. What I dont want is for this message to appear at every time the part runs after the first one. We run alot of lot checks so I need the message on the first part then when i run the next 20 parts i don't want to see it. Can this be done.
    Thanks ahead of time.
    B. Jacobs
    B&S Global 12.15.10
    2014.1

  • #2
    If you use marked sets you can have one set with the comment marked and another without.

    Alternately you could mark all and run with the comment then manually unmark the comment for the rest.
    PC-DMIS 2016.0 SP8

    Jeff

    Comment


    • #3
      If you are running multiple parts have you tried looping?


      BS
      Windows 7
      Pc-Dmis 2015
      Global Performance 7-10-7


      Comment


      • #4
        Looping? I have read about this on here but have never used. I am still new to this. How would this work?
        B. Jacobs
        B&S Global 12.15.10
        2014.1

        Comment


        • #5
          I use a comment

          C1 =COMMENT/YESNO,Do you need to view set up Instructions?
          IF/C1.INPUT =="YES"
          COMMENT/OPER,Place Part on Blocks in center of table per
          ,view in bottom left view of Sheet 1
          ,Part Numbers Face UP and to the left and rear
          ,

          END_IF/
          They would still have to click yes or no
          sigpic
          if you had soap on a rope it would be tied to yer ankle

          Comment


          • #6
            This should work.

            IF/COUNT == 0
            COMMENT/OPER,Set up risers. Blah blah.
            END_IF/
            ASSIGN/COUNT = 1
            <part program>

            As long as you don't close out of your program the operator comment should only appear the first time.
            "Your mom goes to college."
            Kip

            Comment


            • #7
              STARTUP =ALIGNMENT/START,RECALL:, LIST= YES
              ALIGNMENT/END
              MODE/MANUAL
              PREHIT/ 6
              RETRACT/ 6
              MOVESPEED/ 300
              TOUCHSPEED/ 6
              FLY/ON,3
              LOADPROBE/P3_35_B
              TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
              FORMAT/TEXT,OPTIONS,ID,HEADINGS,SYMBOLS, ;NOM,TOL,MEAS,DEV,OUTTOL, ,
              C1 =COMMENT/INPUT,NO,'Part number:'
              IF_GOTO/C1.INPUT>1,GOTO = L1
              COMMENT/OPER,NO,Place part on.................!!!
              L1 =LABEL/

              Try this!
              I hope it will help

              Comment

              Related Topics

              Collapse

              Working...
              X