Graphical Report control

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Graphical Report control

    I am dimensioning a scanned line across the face of a part using Profile of a Line. I have a dozen or more to do like this and it slows the report down considerably. Is there a way to turn on the graphical ONLY when at high limit or over tolerance??
    Thanks!
    sigpicTAU ALPHA PI INDIANA DELTA CHAPTER
    "Due to the highly confidential nature of my job, I am not allowed to know what I am doing" - author unknown

  • #2
    Maybe by putting the graphic in a Custom Report, and showing that IF oot? (One CR for each graph)
    AndersI
    SW support - Hexagon Metrology Nordic AB

    Comment


    • #3
      Do a IF/END_IF statement with an analysis command inside of that.

      Code:
      DIM 13A= PROFILE OF SURFACE OF SET DIMPLE_PLN    FORMANDLOCATION  UNITS=MM ,$
      GRAPH=OFF  TEXT=OFF  MULT=20.00  ARROWDENSITY=100  OUTPUT=BOTH
      AX    NOMINAL        MAX        MIN       +TOL       -TOL        DEV     OUTTOL
      M        0.000     -0.014     -0.115      0.100      0.100      0.115      0.015 <--|----
                  IF/13A.OUTTOL>0
                    ANALYSISVIEW/13A,,
                  END_IF/
      Last edited by bfire85; 09-19-2019, 05:35 PM.

      Comment

      Related Topics

      Collapse

      Working...
      X