Operator Mode w/ Bladerunner

  • Filter
  • Time
  • Show
Clear All
new posts

  • Operator Mode w/ Bladerunner

    We are running 3.7 mr2 and I'm wondering if there is a way to run bladerunner using operator mode, or if the programs are made read only will we have problems getting them through bladerunner? All of our programs are run by operators on the shop floor using bladerunner and we have recently had problems with unauthorized changes being made. Also, each part runs 2 consecutive programs and during the changeover from one to the other I've noticed that the program can unknowingly be changed if I am typing in an office program. I need to find a way to protect against these issues. Any ideas?

  • #2
    roscek, a very late answer, but I believe that Hexagon could update BladeRunner for you to run it this way (in fact make sure there isn't a setting already.) PM me if you need more help.

    "The best way to predict the future is invent it. This includes your very next action."

    Support: Hexagon Metrology Support Center
    Training: Hexagon Metrology University


    Related Topics