Good Morning.
I have just upgraded form 3.7mr3 to 4.1.
Today I tried to run a Blade program but Blade was unable to interpret the "blade.RTF file". When I open the rtf file the format is in a sequential list, not as it appears in the DMIS report file, (text only).
This gets thrown out by Blade. Any ideas?
Thanks.
I have just upgraded form 3.7mr3 to 4.1.
Today I tried to run a Blade program but Blade was unable to interpret the "blade.RTF file". When I open the rtf file the format is in a sequential list, not as it appears in the DMIS report file, (text only).
This gets thrown out by Blade. Any ideas?
Thanks.
Comment