Tweet
Why am I seeing M1 and M in datapage for profile? What is M1?: confused:
-
-
Same problem
I logged on to ask the same question. -
I am a noob myself so do not take my word alone. but I think and again I am a noob 1 is a bi lateral distribution and one is a uni lateral. Of course I am going the 18th for the curves and surfaces class so if I am wrong ignore me it just I have seen this myself and I think that is what I saw but with out the CMM in front of me I cannot say for sure. Sorry if I confused you moreSince I gave up hope I feel much better !!!Comment
-
Hi gang. I have a gd&t question. pic attached. This is not a typical profile correct? where I can use +/-.03 on the profile?03-09-2017, 07:19 AM -
Guys, is this a legit callout having a SR .812 +0-.002 and a unilateral profile .002 ?
They want me to measure the profile, I just think...05-06-2015, 03:41 PM -
Could anyone tell me why when you check the profle of a surface it is doubling your actual readings? Ex. Max> .0076 / Min> .0049-----So my profile...10-09-2006, 01:52 PM
-
Let's say you're results on profile points come out to lowest -.007 and highest +.016.
The profile callout is .020 and profile of line is .010....05-10-2012, 09:47 AM -
I have a part that has a profile called out to ABC and a tolerance of +,- 3mm but the part is fails when measuring on CMM. So here at work an Engineer...10-19-2017, 04:05 PM
Comment