Pattern offset and paste with pattern doesn't work now

[homer.tan]

Hi,

I am using 2011 MR1 and try to use edit|pattern and edit|paste with pattern in the program, but it doesn't work now(it works sometime before). Any help will be warmest welcomed.

[corelex]

Before this thread explodes with comments like ,,,,,well, the usual ones. I will say, I believe you buddy.

But still I must ask, if you changed some parameters in Pattern before the paste? Because this is essential that you do that.

But if you did that, then I was told just recently, that coffee from the vending machines makes the Demon very mad. Did you drink coffee from the vending machine? It could be that this is your major cause for paste with pattern not working.

[Curty_82]

I use 2011 MR1 and use paste and pattern a lot never had an issue.. what does it do whrn you try to use it??

[DaSalo]

Darn! Coffee from the vending machine!? Say it ain't so! There goes my last joy in life.....

[corelex]

Darn! Coffee from the vending machine!? Say it ain't so! There goes my last joy in life.....

Yep, it is sad. Life at work will never be the same

[Lon Fels]

Hi, I have found a minor glitch with the pattern dialog box in 2011 mr1 but it doesn't mean it isn't working. For me, when you enter a value (X, Y, Z) to offset, the controls in the dialog box go dim. To get it to "undim" select an axis to flip and then select no flip, enter your X, Y, or Z value and tab to the number of times to pattern and it will work fine. This will happen every time that you attempt to enter a new value but if you reuse the value last input all you need to do is "paste with pattern". Tech support is aware of the glitch.

[NinjaBadger]

Often when you paste with pattern the graphics look screwed (this is because for some reason it computes the actuals/measured values incorrectly) - think this has been from 2011 but could have been from 2010 sometime.

The nominals/Theo's are however correct, run your program offline the graphics/actuals sort themselves out.