Temp Comp Issue v2011

**lfindustries_cmm** · 03-12-2012, 07:48 PM

I seem to be having an issue with the Temp Comp command in PC DMIS CAD++ 2011 Release. I enable temp comp via clicking the check box in the parameter window and run the part program to make sure temp comp is on. I look at the report window to make sure that it displays Temperature Compensation is ON. Everything is good. Run a few more parts, it still says that TEMP COMP is ON.

After running the program for a while the report window will read Temperature Compensation is OFF. And sure enough, upon opening the parameter window for TEMP COMP the check box to enable it is unchecked. I am not sure why this is happening. The only reason I can think of is a possible registry permission issue when someone who does not have admisitrative privledges is running PC DMIS.

Any Ideas?

**JEFMAN** · 03-13-2012, 03:39 AM

It was one of the bugs of 2011 realease. It's fixed in 2011MR1. If you can't change the version, you just have to change the "time before reading temperature", like 10 sec for example, and during this time, say to the operator to "recall defaut parameters"... It's very boring, I'm happy that it has been fixed in MR1...