If you use the profile to report a plane point, surface, or line, it will give you a different value to the T points which are basically the xyz calculated value away from cad surface relevant to...
As concentricity is basically two centre points measured on the same working plane if the plane is levelled to the datum required then the result of the two circles
centres are projected over each...
Hexagon Metrology Talking Points Blog
Recent Forum Posts
If you use the profile to report a plane point,...
If you use the profile to report a plane point, surface, or line, it will give you a different value to the T points which are basically the xyz calculated value away from cad surface relevant to...
peter mitchell Today, 12:56 AM